Tab Conan
Nov 22, 2019 10:45
The Japanese sex doll's replacement finger line (2.5mm copper wire) is still usable and has been in use for almost 12 months. When I change my thumb after a few weeks, I have to delete it all. Now cut the end of the wire a little to stop the stamp. These hats are easy to print. I have thought about printing a strong hand/finger skeleton with nylon 3D, but think this is a bad idea. It needs to be thicker than existing wires, and the connectors will loosen over time. The original wire twisted pair is very thin, and there is some kind of string around them that mix into tpe, which is a pretty version of the skeleton package, so you can't touch anything. My first thought was to replace the Japanese sex doll's original wire with a 2.5mm single wire to cover the wire to prevent further finger puncture, and when I push the wire through my finger, all I have to do is to separate the fingers. Removing the wire and string may cause the finger to split because the tpe and wire of the finger are wrapped around the string.